How to Tie Down a Fridge in a Truck Bed

Step-by-step guidance on how to tie down a fridge in a truck bed using ratchet straps and cargo anchor points, plus answers on keeping it from slipping.

3 min read0 viewsHow to Tie Down a Fridge in a Truck Bed
— · 0 votes
Contents
  1. Prepare the fridge and the bed
  2. Choose straps and anchor points
  3. Stop the base from sliding
  4. Questions about securing a fridge in a truck
  5. How do you tie down a fridge?
  6. Can you lay a fridge down in a truck bed?
  7. What straps should you use to tie down a fridge in a truck?
  8. How do you keep a fridge from slipping in a truck bed?

Tying down a fridge in a truck bed means blocking its base, strapping the body to cargo anchor points with ratchet straps, and checking the load before you drive. A fridge is heavy and top-heavy, so the aim is to stop it sliding and stop it tipping during turns and braking. The steps below cover how to tie down a fridge in a truck and which parts of the appliance you can safely pull against.

Prepare the fridge and the bed

Preparing the fridge for truck bed fridge securing starts with emptying it and removing loose shelves and drawers. Tape the doors shut so they cannot swing open on the road, and lay a rubber mat or a sheet of plywood on the bed to add grip. A fridge lying on its back or side puts stress on the compressor, so check the maker's guidance on transport position first. Let a fridge that traveled on its side stand upright before you plug it in again.

Choose straps and anchor points

Ratchet straps rated for the weight of the fridge are the right tool for holding it against the truck bed. Use four straps in a cross pattern from the fridge body down to the cargo anchor points at the corners of the bed. Hook each strap to a fixed anchor rather than to the bed rails, which can bend under a heavy load. Keep the straps clear of the door seals and the rear coils so the pressure sits on the cabinet frame.

Stop the base from sliding

Fridge slipping is prevented at the base before any strap is tightened. Set the fridge against the front wall of the bed or wedge it with timber blocks screwed or clamped to the bed floor. Chocks take the sideways load so the straps only have to hold the fridge down and upright. Shake the fridge by hand after tightening, and retighten the ratchet straps after the first few miles of driving.

Questions about securing a fridge in a truck

How do you tie down a fridge?

Tying down a fridge means holding the cabinet body to fixed anchor points with ratchet straps while the base is blocked against sliding. Run straps over the frame rather than the doors or coils, and tighten them until the fridge cannot rock. Check the straps after the first stretch of driving and tighten them again if they have loosened.

Can you lay a fridge down in a truck bed?

A fridge can travel on its side only if the maker's instructions allow it, because oil can move into the cooling lines. Many makers ask you to keep the fridge upright and to let it stand upright for a period before switching it on after any tilted trip. Follow the transport guidance for your model and strap it upright whenever the manual calls for it.

What straps should you use to tie down a fridge in a truck?

Ratchet straps with a working load limit above the weight of the fridge are the right choice for this job. Choose straps with hooks or flat hooks that fit your cargo anchor points, and use four so the load is held from more than one direction. Rope can work as a backup but it stretches and loosens as the truck moves.

How do you keep a fridge from slipping in a truck bed?

A fridge is kept from slipping by chocks or timber blocks at the base plus a nonslip mat under it. The blocks carry the sideways force while the ratchet straps hold the fridge down against the bed. Check the anchor points and the strap tension each time you stop during the trip.

Latest articles