# Set Up a Beach Water Station

Plan a beach water station with drinking water, a separate rinse-off tap, cups, ice and shade. Lay out the jugs on stable ground away from the surf.

A beach water station is a portable spot on the sand where your group fills cups, cools off and rinses salt and grit from hands and feet. Set up two jobs at once: a clean drinking supply and a separate rinse-off supply, each with its own container and its own tap. Place the station on level, packed sand above the tide line, weigh the containers down and shade them so the water stays cool through the day. 

## Split drinking water from rinse water 

Keep the drinking side of a beach drink station apart from anything used for washing feet. Use water jugs with a spigot for drinking and a second, clearly labeled container for the beach rinse station. Never let a cup or a hand dip into the drinking supply, and set the two taps far enough apart that wet feet cannot splash the cups. A beach wash station handles salt, sunscreen and sand, so its runoff belongs on the sand and not near the cups. 

## Lay out the station on the sand 

A water station layout on a sandy beach starts with flat, packed ground above the reach of the waves. Set the containers on a board or a low table so taps sit at a comfortable pouring height and do not sink. Arrange the cups, a bin for used cups and a small towel line in one line, so people move through without crowding the spigots. Dig a shallow channel for rinse runoff if the sand is fine, and keep the whole station a few steps from where people sit. 

## Hold the water cool and stable 

Shade and cooling for water matter as much as the supply itself, because warm water gets refused on a hot beach. Place the station under a canopy or an umbrella and wrap jugs in a damp towel if you have no shade. Fill containers at home with ice and top them up, and keep a spare jug sealed until the first one empties. Weight the base with sand or a filled bag so a gust of wind cannot tip the station over. 

## Beach Water Station Questions 

### What is a beach water station? 

A beach water station is a portable setup that gives your group drinking water and a way to rinse off during a beach day. It holds water jugs with a spigot, cups, ice and a separate rinse-off container in one shaded spot on the sand. The station is laid out so people can fill a cup and wash their feet without mixing the two supplies. 

### How do you set up an outdoor hydration station for a group? 

An outdoor hydration station for a beach group needs one clean drinking supply, one rinse supply, cups and shade. Fill water jugs with a spigot, pack ice in a separate cooler and label the rinse container so nobody drinks from it. Place the jugs on stable ground above the tide line and keep a bin nearby for used cups. 

### Where should a beach rinse station go? 

A beach rinse station belongs a few steps away from the drinking side and away from where people sit. Choose flat sand above the surf line so rinse water drains away from the cups and does not pool underfoot. Point the runoff toward bare sand and keep the tap low, so users do not spray water onto the drinking supply. 

### Can one station handle both drinking and washing? 

One beach wash station and a drinking point can share a frame, but they should never share a tap or a container. Two clearly labeled containers with separate spigots keep drinking water clean while the rinse side takes salt, sand and sunscreen. Set the drinking jug higher and the rinse tap lower, so splashes fall away from the cups.
